1. Product introduction

LCD TV ceiling flippers are mainly used in various conference halls, trading halls, multimedia network systems, and office furniture. The flippers place the TV on the ceiling, and the TV can be flipped from the ceiling by remote control. Next, the product is installed and easy to operate, and the LCD TV can be stored on the ceiling when not in use. It has a protective effect on the TV. When the flipper is turned on, the LCD screen will automatically flip to a 90 degree angle (special requirements can also be designed separately).

2. Features

1. Electric control, easy to flip

2. Flexible use and good stability

3. Manual control, wireless remote control

4. Centralized control, support central control

5. Easy installation and simple operation

3. Technical parameters

Product Brand: Jinggu

Product model: JG65

Suitable for TV: 32-70 inches

Product weight: 39KG with packaging, 32KG net

Product load: 60KG

Product material: cold rolled steel

TV angle: 0-90°

Rated voltage: 220V

Product size: 620*580*220mm (length * width * height)

4, matters needing attention

1. When the flipper is in operation, no one can stand underneath, nor place any objects that may touch the flip frame.

2. The flipper cannot be overloaded.

3. Do not start the flipper frequently.

5, Packing List

6, control method

(Both port 232 and port 485 are common)

1. RS485 serial port control with feedback information. Operation method:

Baud rate: 9600 Check digit: NONE Data bit: 8 Stop bit: 1 Hexadecimal address code.

Format+Operation Code+Address Code+Post Sequence

7E 04 A3 00 01 7E (Settings)

7E 04 A0 00 01 7E (rising)

7E 04 A1 00 01 7E (decrease)

7E 04 A2 00 01 7E (stop)

Serial port rs232, 1 pin is connected to 5 of 232, pin 2 is connected to 3 of 232. Baud rate is 9600, parity bit: none, data bit: 8, stop bit: 1, hexadecimal address code. Rising. 7e04a000aa7e. Falling 7e04a100aa7e. Stop: 7e04a200aa7e.

If you change the address code of this station:

7E 04 A3 00 02 7E Specify the address code of this circuit board, and the original address code is automatically deleted.

Format: 7E 04

Operation code: (A0: rising) (A1: falling) (A2: stop) (A3: setting, modification)

Hexadecimal two-digit address code: For example: the first one: 00 01 the second one: 00 02

Post order: 7E

The circuit is fixedly set with address code 00 AA, and another set address can be stored concurrently.

2. Easy to learn

The learning key receives the signal code. Operation method: Press the learning button once, the learning signal light is on, and then press and hold any key of the remote control (up, stop, down) until the learning signal light goes out. Explain that this remote control can be used.

3. Stroke adjustment

1. The upper stroke has two stroke switches that can be adjusted, which will stop when touched.

2. There is a limit switch for the lower stroke to adjust.