1. Product introduction

The cross-scissor lifter, also known as the electric projector hanger, has the advantages of simple structure, beautiful appearance, light weight, super load, convenient installation, convenient debugging, heavy load bearing, low power consumption, low failure rate and so on. It has always been expected by users in the industry. After years of unremitting efforts, our company has finally developed a series of internal wiring, which can be customized for 0-5m travel, simple and accurate positioning, and a true cross-cutting type with low failure rate Electric hanger.

2. Features

3. Electronic limit: The elevator can set upper and lower limits through the remote control code pairing, which is simple and convenient to operate and precise positioning;

4. Customized itinerary: 0 to 7-meter telescopic itinerary can be customized according to demand, with mature technology and fast shipping cycle to meet the individual needs of customers;

5. Stable operation: The square cold-rolled steel base is matched with a thick webbing transmission, which makes the operation stable and quiet;

6. Intelligent control: support wireless radio frequency remote control, line control button switch and central control RS485 serial port control;

7, product parameters

Brand: Jinggu

Product model: B210

Product material: cold rolled steel + baking varnish

Product size: 530*470 (mm)

Color: white (default as shown in the figure, real shot)

Descent stroke: 1 (can be customized to 7 meters)

Transmission: Wire Rope

Product weight: 50kg

Product weight: 35KG

Remote control distance: 20M.

Working temperature: 0~45℃.

Relative humidity: not more than 80% (20±5℃)

Power requirements: (1), power supply voltage AV200V±10%: 50HZ; (2), maximum power: 25 W

Packaging details: First layer: foam/film Second layer: carton

1. Control method:

(1). Manual control.

(2). 315M radio remote control.

(3). Central control system RS232, RS485 control.

3. Packing list

1. Description of Intelligent Control

1. Remote control

(1). Lower the electric hanger to the midpoint.

(2). Use the pen tip (small screwdriver) with the red button in the small hole on the back of the remote control to hear two buzzers to enter the positioning setting mode.

(3). Press the up button on the remote control to enter the up positioning setting mode. After ascending to near the predetermined point, press the down or up button of the remote control to enter the step mode. After reaching the determined highest point, press the stop button to confirm the up positioning. After hearing two buzzers, the positioning is successful.

(4). Use the pen tip (small screwdriver) again with the red button in the small hole on the back of the remote control to hear two beeps and enter the positioning setting mode.

(5). Press the down button of the remote control to enter the positioning learning mode. After descending to near the predetermined point, press the up or down button of the remote control to enter the step mode. After reaching the determined lowest point, press the stop button to confirm the next positioning. After hearing two buzzers, the positioning is successful.

2. Central control serial port control

(1). Side connection method

(2). Data transmission port parameters

Baud rate 9600

Data bit 8bit

Check digit None (NONE)

Stop bit 1bit

Hexadecimal control code

Set the serial port address: 7E 04 A3 00 AA 7E

Down: 7E 04 A1 00 AA 7E

Last rise: 7E 04 A0 00 AA 7E

Stop Stop: 7E 04 A2 00 AA 7E

Note: Fill in the address code at **; 00 AA is the public address code (that is, full code control), 00 AA is also the factory default address code, which can be directly logged in and used.

Group control

The electric hangers that need to be assigned to the same group can learn the same address, and use the public address code for full control.